Finish-thompson DB 11/15 Series Uživatelský manuál

1

10 Check the impeller thrust ring and bushing for wear. See figure 16.6. Remove the impeller shaft (item 6) from the barrier and check for s

11Impeller ReplacementCaution: Do not damage the outer surface of the inner drive magnet during impeller replacement. Using the two slots provided,

127. Install o-ring (item 2). See figure 39.8. Install impeller shaft (item 6) into barrier by aligning the flats on the shaft with the on

131. Select Base Model (Example: DB11P) * 2. If Standard Components aren’t suitable, enter symbol(s) of alternat

14DB11 / DB15 Exploded View - Parts Diagram

15DB11/15 Spare Parts ListItem Qty DescriptionDB11 DB15Pump Material Pump MaterialPolypro PVDF Polypro PVDF1 1Standard Housing with RingNPT threads &a

16*Cast iron motor adapters have been upgraded to polypropylene effective August 2009. To upgrade, order one of the options in item 8 above. For IEC 8

17DB11/15 Spare Parts List - cont.Item Qty DescriptionDB11 DB15Pump Material Pump MaterialPolypro PVDF Polypro PVDF10 1Motor Adapter Flange182/184TC f

18HARDWARE - ALL DB11-15 MODELSItem Qty Description Stainless Steel Titanium12 8Housing Bolt105755 10575613 8Housing Lockwasher105757 10575814 8Housin

19Section VII - TroubleshootingGeneral Notes:• Do not pump liquids containing ferrous metal fines.• If magnets decouple, stop pump immediately. Opera

2EU Declaration of ConformityFinish Thompson Inc. hereby declares that the following machine(s) fully comply with the applicable health and safety req

3TABLE OF CONTENTSImportant Information ... 4

4WARNING: READ THIS MANUAL COMPLETELY BEFORE INSTALLING AND OPERATING THIS UNIT. FAILURE TO FOLLOW THESE PRECAUTIONS CAN RESULT IN SERIOUS INJURY OR

5OUT CAUSING DAMAGE TO THE PUMP. However, the pump can operate without liquid in the casing if the pump has a carbon bushing. The exact length of tim

6 NOTE: Make sure the motor shaft is clean and free of burrs. The outer drive is precision machined and has a bore tolerance of +.0005/-0

7 Tip the pump end at an angle (discharge is approximately 45º) so that it is just touching the edge of the outer drive magnet assembly. See fig

8Motor/Electrical Install the motor according to NEC requirements and local electrical codes. The motor should have an overload pro- tection

91. Stop the pump, lock out the motor starter, close all the valves that are connected to the pump, and drain/decon- taminate the pump. W